Warning

Caution: Use only on 120 volt 60Hz circuits. Suitable for damp locations. Minimum starting temperature -13 degrees F (-25 degrees C). This device is not intended for use with emergency exit fixtures or emergency lights. Do not use with dimmers. When installing, make sure that power is switched off before connecting or disconnecting to fixture. Do not look directly into the light. For more information visit www.feit.com or call our toll free number 1-866-326-Bulb. The performance specifications (lumens, watts, life, CCT, and CRI) printed on this LED product package should only be considered an approximation of expected performance. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.