Clorox Plus Tilex Mold & Mildew Remover

Product details

Kills 99.9% of mold & mildew. Contains Bleach. Spray every drop! Whitens brilliantly. Contains no phosphorus. Smart tube technology. Works on: Glazed and unglazed ceramic tile, grout, tubs, shower doors, vinyl curtains. Fiberglass, counters, sinks, plastic.

Warning

First Aid: If in Eyes: Hold eye open and rinse slowly and gently with water for 15-20 minutes. Remove contact lenses, if present, after the first 5 minutes, then continue rinsing eye. If on Skin or Clothing: Take off contaminated clothing. Rinse skin immediately with plenty of water for 15-20 minutes. If Inhaled: Move person to fresh air. If person is not breathing, call 911 or an ambulance, then give artificial respiration, preferably mouth-to-mouth if possible. In All Cases: Call a poison control center or doctor for further treatment advice. Have the product container or label with you when calling a poison control center or doctor, or going for treatment.,Keep out of reach of children. Warning: See back panel for first aid statements. Precautionary Statements: Hazards to humans and domestic animals. Warning: Causes substantial but temporary eye injury. Do not get in eyes or on clothing. Wear safety glasses. Avoid contact with skin. Harmful if inhaled. Avoid breathing spray mist. Wash thoroughly with soap and water after handling and before eating, drinking, chewing gum, using tobacco or using the toilet. Remove and wash contaminated clothing before reuse. For sensitive skin or prolonged use, water rubber gloves. Not recommended for use by persons with heart conditions or chronic respiratory problems such as asthma, emphysema or obstructive lung disease. Physical and Chemical Hazards: This product contains bleach. Do not use or mix this product with other household chemicals, such as products containing ammonia, toilet bowl cleaners, rust removers, vinegar or acid. To do so will release hazardous gases.

Additional info

Directions for Use: It is a violation of Federal law to use this product in a manner inconsistent with its labeling. Avoid prolonged breathing of vapor. Use in well-ventilated areas. Open windows and turn on fans before use. If the vapors bother you, leave the room while this product is working. To Disinfect & Kill Mold & Mildew on Hard, Nonporous Surfaces: Turn nozzle to on. Spray surface until thoroughly wet, let stand 5 minutes and rinse. This product kills Salmonella enterica, Staphylococcus aureus, Streptococcus pyogenes, Trichophyton interdigitale (Athlete's foot fungus) and Aspergillus niger. To Remove Mildew Stains: Spray 6-8 inches from surface until surface is thoroughly covered. Allow foam to deeply penetrate mildew and problem areas. Wipe with a wet sponge or cloth, and rinse. Heavy mildew buildup may require longer contact time or two cleanings. To Kill Mold & Mildew on Hard, Porous Surfaces Such as Grout and Cement: Spray surface until thoroughly wet, let stand 10 minutes and rinse. Rinse immediately after use on rubber, plastic and vinyl. Avoid prolonged contact with metal and old porcelain as this product can react with these materials and leave a rusty stain. To Spray Every Drop: Tilt bottle at a downward angle while spraying. To Refill: Turn trigger on spray bottle counterclockwise and pull upward to remove. After refilling spray bottle, replace trigger by aligning red tube on trigger with small opening inside bottle and push firmly down. Storage and Disposal: Store this product in a cool area to avoid deterioration. Do not reuse or refill except as described in the directions for use. Refill only with this product. Recycle empty container or discard in trash. Align to close.